Irritrol Total Control-R Series Manual de usuario descargar pdf (Pagina 4)

Controller Components

▲ FIGURE 1

1 LCD Display: For viewing time, program and status information.

2 + /On & – /Off Buttons: For entry of program information.

3 Next Button : For selection of information to be programmed or reviewed.

4 Function Dial: For selecting the programming and operating functions.

5 Current Time/Date : For setting the current time and date.

6 Station Times : For setting individual watering time for each station.

7 Program Select Switch: For selection of programs A, B, C or D.

8 Start Times : For setting the time each program cycle will start.

9 Water Days : For setting a watering day schedule for each program.

10. Water Budget : For the increase or decrease of station times for all

stations within a program without changing program memory.

11 Program Erase: For erasing information within a selected program.

12 Manual Program Cycle: For starting manual operation of a selected

program watering cycle.

13 Manual Single Station: For timed or untimed operation of a single station.

14 Rain/Off : For immediate shut down of all controller output.

Programmable output delay for 1–7 days (Rain Delay).

15 Run : For automatic operation.

▲ F

IGURE 2

16 Mounting Holes: Pilot screw holes for attaching the outdoor controller to the

wall. For indoor controller mounting holes, see page 19 Figure 4.

17 Safety Fuse: Replaceable 2.0A slow-blow fuse provides protection from an

internal short-circuit condition.

18 Sensor Control Switch: To override rain switch sensor input.

19 Sensor Connection Terminals: For the connection an optional (normally-

closed)rain switch device.

20 Valve Common Terminals: For the connection of up to three field (24V)

common wires.

21 Earth Ground Lug: For connection of a 16–12 gauge (1.0–2.0mm

) copper

ground wire to an earth ground.

22 1/2" NPT Conduit Nipple: For the connection of an electrical conduit

access body for input power wiring. Applicable to outdoor models only.

23 Valve Wire Terminals: For the connection of valve control wires.

24 Master Valve Terminal: For the connection of a master valve or pump start

relay control wire.

25 Battery Compartment: 9-volt alkaline battery access compartment.

Note: Plug-in power transformer for indoor controller not shown.

CONTROLLER COMPONENTS

1 2 3 4 5 6 7 8 9 ... 31 32

Sin comentarios

Irritrol Total Control-R Series Manual de usuario Pagina 4